Crawlspace Clean-Up & Control Earth Moisture in Steamboat Springs, CO

Before	After

The groundwater seepage from this crawlspace had resulted in mold affecting the surfaces of the wooden structural elements and paper-faced insulation in the subfloor & walls. We removed the insulation and cleaned the structural elements - drying them & coating in a white breathable EPA registered fungicidal coating. In order to prevent this from happening again - we installed a drainage system gravity fed to a SmartSump Pump System to pump water to the exterior and away from the foundation. We also added Drainage Matting, Terrablock Floor Insulation, & sealed 20 mil antimicrobial & cord reinforced liner to the earth and walls for a true CleanSpace Encapsulation System. We air-sealed perimeter rim penetrations and reinsulated. This crawlspace is warranted to be free from minor damage to the liner and ground water on top of the liner for 25 years!

Encapsulation System Install - Steamboat Springs

Before	After

After removing debris, damaged insulation and a light contour of the dirt surface, we then placed our hepa air filtration equipment.

After the initial work was completed we did some minor mold remediation work to complete the preparation process.

Once the preperation work was completed we were able to install our encapsulation system and sump pump along with proper drainage channels in order to effectively remove all water and moisture from the crawl space.

Annual Service - Contour Outside For Drainage

Before	After

We went out for our annual service on the CleanSpace System. Once we performed the pump and liner cleaning, we contoured the outside drainage trench and pipe for optimal drainage.